Ordered Unit on May 25th and Received the KPA500 last Monday August 1st. After Parts Inventory Assembly started at 8 AM on Tuesday, August 2nd. Powered Up and Wired Into The System - 5 Hours Later.
>From the earlier post I expected missing screws, assorted hardware, Buzzing >X'formers all sorts of small issues. Let me report that the unit is running on 220 Volts (Red Tap) Volt Reading is 80.4 Volts. No Buzzing, Not a Single Screw or Hardware Missing and Power Output at ranges between 20 - 30 watts input, output is between 500 - 600 watts. Other than an issue with the PA not transmitting on 6 Meters because of the use of the PR6 6 Meter RX Pre- Amp, I have had "0" Issues after just short of a weeks usage on all bands! I am using the KPA500 as a Standard PA Operation being keyed via the PA Key Line between the K3 and the KPA500. The PR6 Compatibility Issue will be addressed in the next Firmware Release 1.09. Elecraft offered to send me the file but I will wait until it is released and fully ready to go. All in all the KPA500 Assembly and Operation exceeds my expectations. WELL DONE ELECRAFT!!!!!!!!!! WELL DONE!!! Richard Griest - WB4VMH ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
