> That ACC jack tip is for an INPUT to the FT-857/897. I.e., grounding
> this input puts the radio into a CW transmit mode for tuning an
> external tuner.
Not according to the FT-897 Operating Manual, page 18 (Rear Panel
Connections). This may be yet another case of blatantly incorrect
data in Yaesu's manuals but I referred directly to the manual before
posting the information.
73,
... Joe, W4TV
On 8/10/2011 7:04 AM, Phil & Debbie Salas wrote:
> "The FT-897 has an "extra" TX GND signal on the tip of the ACC jack.
> A cable with stereo 3.5mm plug to RCA plug can be used to connect
> the ACC jack to the KPA PA Key jack ... an off the shelf 3.5mm stereo
> to 2 x RCA cable can be used for ALC and PA Key if desired."
>
> That ACC jack tip is for an INPUT to the FT-857/897. I.e., grounding this
> input puts the radio into a CW transmit mode for tuning an external tuner.
> The ring is ALC. You must use the miniDIN8 connector for amp keying.
>
> Phil - AD5X
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
