Thanks! I have received a technical response to my question. Tom - W4BQF
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Tommy Alderman Sent: Wednesday, August 17, 2011 5:30 PM To: [email protected] Subject: [Elecraft] P3 Manual Calibration procedure question I'm sure this has been discussed before but if so, I have missed it. On page 24 of the P3 Owner's Manual, Rev. B, March 29, 2011, under the heading of Amplitude Calibration the forth button down, it states to set the signal generator for 7040 kHz and the following button below says to set the transceiver to approximately 7015 kHz so the signal is centered on the right half of the display. Is this a typo? If not, can someone please explain the purpose of doing this? Thanks and 73 Tom - W4BQF ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
