Andy, If the KPA100 has red core toroids at L15 and L16, it is the old level and the KPA100UPKT should be installed. If there are blue core toroids at RFC1 and L16, it has already been installed.
73, Don W3FPR On 8/21/2011 2:30 AM, andyatd wrote: > Don, > > Reading the KPA100 manual I anticipated re-alignment and setup would be a > good idea. The procedure looks straightforward and I do have adequate > equipment for the process. The KPA100 will be installed on a 48xx series > serial number K2 and I am not sure whether the KPA100UPKT has been installed > or not, but I will do so if it is not. > > Thank you for your recommendations. > > Andy > N3LCW > > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/KPA100-Installation-Q-tp6707741p6707897.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
