Let me second Nigel's request and recommendation; it is excellent well
supported software; I use it as well; the K2 serial interface cable
works well supporting the remote control options and passing frequency
and mode to the programs.
Aside from the microHAM products, it also does well with the rig blaster
series as well.
I do wish someone would make a proper cable set for the K2 to microHAM
microKEYER though; it would make it easier to get a nice portable setup
going...
73 de W5SV, Dave
Nigel wrote:
I notice that the DxLab suite of programs, which fully supports the K2
interface, is not listed in the list of software. I use it and find it very
good.
This is a freeware suite of programs with great support from an active
community of users via an email reflector and a provided by a very pleasant
and talented designer. Logging, Call sign Look up. Propagation
prediction, Rotor drive, Spot collecting, MapView and Digital modes support
plus CW sending are included. It also Interfaces well with MicroHam
products.
It can be found at
http://www.qsl.net/dxlab/
Perhaps it could be added to the Elecraft List?
--
David F. Reed - W5SV - cell: 512 585-1057
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
