I have seen lots of posts on the filter setup on the K3 with regards to gain
and also changing the filter value entered compared to the value of the filter
itself. I just installed the general coverage unit in the main receiver along
with a 6khz filter. This brought me back to the filter setup question. Just
wanted to get some input from elecrafter's and their filter setting setup's.
My K3 filter line up is a follows:
Main
2.7Khz stock 5 pole crystal filter offset at -0.76
6Khz 8 pole inrad filter (I purchased this filter as the general coverage
receiver is installed)
500hz 8 pole inrad filter
400hz 8 pole inrad filter
250hz 8 pole inrad filter
Sub
2.7Khz 5 pole cystal filer offset at -0.90
500hz 8 pole inrad filter
400hz 8 pole inrad filter
250hz 8 pole inrad filter
One last question.....In the main receiver where the general coverage unit has
been installed I added the 6khz filter. For some reason I installed the 6khz
flter after the 2.7 on the K3 board. I really don't want to take the radio all
apart but if the 6khz should be in slot 1 then I will.
Mike
VE3WDM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
