Hi Bill, Just to be sure I understand, With the coax connected to the tripod, the antenna connected to the tripod, with the only connection left to connect would be the coax to the radio... if you measure across the coax there is no short? And there is conductivity from the pin to the antenna? Just making sure I understand, Thanks,
--... ...-- Dale - WC7S in Wy > Date: Sat, 27 Aug 2011 18:34:32 -0700 > From: [email protected] > To: [email protected] > Subject: [Elecraft] An Antenna Problem I Can't Figure Out > > I am trying to temporarily use a 20 m Hamstick on my > Outbacker tripod. The base I am using checks out fine with > nothing attached. In other words, the top where the antenna screws in shorts > with the pin on the UHF connector on the bottom of the base and is isolated > from the tripod. When I connect a non-terminated coax to the base connector > everything continues to check out as above. However, as soon as I connect the > other end of the coax to ANT 1 of the K3, everything is shorted together (the > top where the antenna screws in shorts with the tripod) and the KPA500 shows > infinite SWR. The Hamstick folks couldn’t figure it out and HRO here in > Phoenix > was kind enough to exchange the Hamstick for another, with no effect. Any > ideas > and/or explanations? Thanks and 73, Bill N4IEZ / F4WAE > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
