Hi Eric et. al., I wonder if it would be possible to have the INHIBIT# enable/disable be on a per-band basis for the KPA500. That way one could use DIGOUT1 to disable the amp on a band, say 17m or some band where the antenna SWR is too high, and to allow it to be enabled on 6m when DIGOUT1 is used to turn on the PR6. One downside of this that I can see is that if DIGOUT1 is used to disable the amp on 17m it would also turn on the PR6 so a receive antenna wouldn't be able to be used on that band.
73, Fred Fred Cady fcady at ieee dot org "The Elecraft K3: Design, Configuration, and Operation" www.ke7x.com > -----Original Message----- > From: [email protected] [mailto:elecraft- > [email protected]] On Behalf Of Eric Swartz WA6HHQ - Elecraft > Sent: Thursday, September 01, 2011 11:45 AM > To: [email protected] > Subject: [Elecraft] New KPA500 1.11 f/w Released > > We have just posted new V1.11 firmware for the KPA500 to the web. See: > http://www.elecraft.com/KPA500/kpa500_software.htm > > 73, > Eric > > www.elecraft.com > _..._ > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
