Tim, If you see no diagonal lines - then remove NOTHING.
Yes there is a film on both sides of the diffuser, and that is a benefit. If the rear side has the diagonal lines, then that film should be removed because the stripes show through. There is no protective film on the back side of the LCD - it is only on the front side. You should remove the front film just before putting the front panel in place - until then, it will protect the LCD surface from scratches wile you are working on the assembly. 73, Don W3FPR > -----Original Message----- > > On page 26 of the assembly manual, the 6th step down, it says do > not remove > the backing from either side of the diffuser, I assume that means to leave > the paper backing on that has the writing on it? > > Also, I don't thing there is a protective film on the back of the > LCD, I do > not see any faint yellow or gray diagonal lines. Would there be > any film on > it without the diagonal lines? > > Thanks > Tim > NZ8J > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > -- > No virus found in this incoming message. > Checked by AVG Anti-Virus. > Version: 7.0.323 / Virus Database: 267.8.1/28 - Release Date: 6/24/2005 > -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.323 / Virus Database: 267.8.1/28 - Release Date: 6/24/2005 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
