I installed the synth stiffener, and now have the following err msgs: ERR PL1
ERR VCO E 00005 ERR VC4 00255 V PL1 *0.0 Assuming that it's not about "is unit plugged in?" and "wiggle the plugs", which I have done, is there any advice? I have the sub rx, so I swapped the two PLL cards, and the problem shifts to PL2. The working card now in PL1 works fine, and so I'm sure the REF osc works. I tested the plate I installed for continuity to ground, and it shows over 20Meg ohms. Very quite careful with smoothing the surface. The CAL procedure causes the relays to operate, so that much is OK. Anyone seen this? Thanks Al NH7O ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
