On 9/12/11 12:03 PM, Lance Collister, W7GJ wrote: > Howdy Bruce, > > Unfortunately, the K3 does not decode JT65A signals, so you must use an > external > computer program such as your JT65HF to send and decode them. You just > connect the > LINE OUT on the computer to the LINE IN on the rear of the K3, and the > computer LINE > IN to the LINE OUT on the rear of the K3. > > GL and VY 73, Lance > Bruce,
Also, make sure once you have it cabled up that you use the DATA mode, verify that it's using the correct sideband (USB is typical for JT-65A ), and select DATA A as the data mode you're using. I'm not in front of my radio but I think you hold "AFX/Enter" key (its labeled DATA MD in yellow) and use the "B" VFO knob to change to DATA A. It defaults to AFSK A, which will not work and might confuse you (it sure confused me but that's not hard to do). 73, -matt nm6w ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
