Tom, The K3 EXT ALC input is on the ACC connector at pin 15 - see the manual page 18 for the ACC connector. The "how to use" is in page 27.
It is likely that you do not need to use the ALC from the amp - the amp ALC should not be used to control the power output from the K3, but if your amp uses ALC to reduce power from the exciter because of an amp fault, that is a valid use of the ALC line. 73, Don W3FPR On 9/14/2011 10:30 AM, Tom wrote: > Where do I connect the ALC from the K-3 to my amp. I' m sure it must be in > the manual, but can't seem to find it. > Tom > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
