I have to totally disagree with Drew's (AF2Z) statement that " the rare close strike probably means everything that is connected will get taken out". Nothing can be further from the truth. The next three paragraphs are quoted from WR Blocks web site (W3FPR specifically mentions Ron Block in his rather verbose dissertation in his email below):
"Our challenge is to assemble the best amateur radio station possible, enjoy the benefits of the hobby, and have our station operable during times of need. This can be a significant challenge especially considering the height of the antenna and the awesome capabilities of Mother Nature's lightning strikes. While she may have the upper hand as far as when and how much energy she delivers, you have the ability to influence how that energy is diverted into the earth. Said another way, you can implement a lightning protection plan that will protect your amateur radio station, even from a direct strike! The commercial radio folks have done this for years; many of them have critical, must operate, installations in some very difficult to reach locations. Many of the installations are located on hills or mountaintops that afford the best area coverage and are great lightning strike targets. They do survive direct strikes and continue to provide important services to the communities that they serve. While this type of solution is possible for the amateur radio station, it does cost money and it does take a significant amount of resourcefulness, ingenuity, and effort to implement and maintain. The plan does work; but you must follow all of the rules, exactly. Any violation of the rules, even just a little one, may result in a violation of the protection plan and damage to your equipment. In some cases the damage to a semi-protected radio station could be worse than if no protection plan had been implemented at all. I'll start with some background and then get into the heart of the matter." Don's (W3FPR) is right on track. I have lived south of Denver on top of a hill since 1993, and moderate to severe thunderstorms seem to be the rule rather than the exception in the Spring and Summer (around 40 or so). Though I can't say that I have ever watched one of my towers take a hit (not in the habit of sitting by a window during a lightning storm and "standing watch" over my towers - I normally hibernate in the shack and use the computer while enjoying feeling the house shake with the close by lightning strikes); one evening (wife and I were out) the fire dept told me they responded to the house after receiving a call from a passing motorist that he saw one of my towers being hit by lightning. They did not find any damage, nor did I after I arrived home and checked everything out. In an earlier post, I mentioned that I did have some damage to the M2 Orion 2800 rotor (on the 120 ft tower) and a diode in one of my Hy-Gain rotor relay switch boxes being shorted after a storm last week. If that is the only two "hits" I have had in 18 years, I am pretty damn lucky; according to the charts, my 120 ft tower has a probability of being hit 2 1/2 times a year based on the number of "thunderstorm days". When I was erecting my "antenna farm" I was well aware of the lightning problems associated with living on top of a hill at 6600 ft; and took the necessary steps to minimize the risks of sustaining substantial damage to my equipment. All I will say is I can't agree more with what W3FPR states; but rather than try and "dig up" old QST articles, just go to Ron Blocks web site (http://www.wrblock.com) and "click" on PAPERS. That will tell you everything you ever wanted to know about lightning protection and what you need to do to effectively "ground" your station. Since I am not a big fan of "practice bleeding", I do not operate during a storm; and I try and remember to disconnect the coax and rotor cables (normally four - five if the 2 mtr radio is connected). However, I have to admit that more than once I did not disconnect stuff prior to leaving and a storm rolled through while I was gone. I can't believe that Drew disconnects everything from his K3, PC and router; I can't imagine the amount of time that must take having to connect and then re-connect every time it is going to storm (I have around 14 or so connected to the K3 - it would take me at least 15 minutes to figure out where each one goes!). Dick K8ZTT -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Don Wilhelm Sent: Wednesday, September 14, 2011 6:01 PM To: [email protected] Subject: Re: [Elecraft] Lightning Strike - Metal Roof attracts? An alternative to unplugging everything -- create a system where everything will be at the same potential through a surge event and you will have no damage. Run a #4 (or larger) perimeter wire around your house (and any other buildings) with a ground rod at each point where it changes direction, connect it with #4 wire to everything metallic in your house structure or outbuildings, and then connect it to the 3 or 4 #4 wires radiating from each of your towers or masts - those radial wires should have ground rods connected at intervals not exceeding twice the length of the ground rods. (8 foot rods spaced every 16 feet, or 4 ft rods spaced at 8 foot intervals, etc.). The length of the radial rods should be at least as long as the tower or mast is tall. Oh yes, all these grounds must connect to the utility ground rod(s) for the house. Anything metallic in the house (including the roof if metal) should connect to this ground system). Install a "whole house" surge protection device at the electrical panel. and put surge suppression devices on incoming TV antenna, cable TV/internet lines, telco lines, etc. In addition, all lines coming into the station should enter through a "grounding window" (a copper or aluminum panel) where your coax lightning protection devices are mounted, the station power comes through this panel too with a surge protection device (do not skimp on the quality), all telco and ethernet, rotator cables, remote antenna switch wires, (everything entering the station). also come through this panel and each conductor is equipped with an MOV or similar protective device. The panel is connected to one or more ground rods (also connected to the perimeter wire and the utility ground point) with good low impedance ground strap (only gentle turns). In other words, *everything* within the station has its connectivity routed through that grounding window, and every piece of equipment in the station and within reaching distance of the operating position is tightly bonded to that grounding window, and all the ground wires and rods are connected to each other. If you do all those things, you may not have to disconnect everything from your transceiver during a lightning storm. As an added benefit, you may eliminate many hum sources in your station's audio system, and the locally generated noise may be reduced. I know all of that is not practical for some existing structures, but take the recommendations as intended, and know where your deficiencies are, then do what you must to protect your home and equipment. I have some of that system in place or in-plan for the near future, but I still do not operate during a lightning event. Each transceiver is connected to a dummy load automatically when I remove power from the antenna relay system for additional protection. A bit of planning will provide you with some protection, but whatever you install, do not depend on it with your life - there will most always be some deficiency, so do take reasonable precautions during an electrical storm (stay away from the operating position). Look at the Safety section of the newer ARRL Handbooks, and review the information on station protection at the Polyphaser website for more detailed information. Ron Block has provided some good information regarding these practices in QST several years ago, sorry but I cannot recall the year, but it was a 3 part article. 73, Don W3FPR On 9/14/2011 7:03 PM, Sam Morgan wrote: > just curious > how many things (actual number please) > do you unplug from both your K3 and the computer/router? > > I know my K3 has 14 or more cables to it > and the radio computer has to have at least that many again > the firewall computer in the other room has 6 > and the router has 3 > then there is the other computers > and the hub...... > > not saying it's not a good idea > just wondering if I should some how simplify my life? > > GB& 73 > K5OAI > Sam Morgan > > On 9/14/2011 5:17 PM, drewko wrote: >> I think i've posted this before: During lightning season I disconnect >> everything from my K3 when it is not in use, including headphones and >> key. Same goes for my PC and router. I leave no cables connected to >> any of these boxes. It is a bit annoying, especially at the start of >> the season when I have to get used to the disconnect/reconnect routine >> all over again. But the alternative is as you have found: the rare >> close strike probably means everything that is connected will get >> taken out. >> >> We also experienced a lighting storm Sun night, here 150 miles to your >> east. Maybe it was just the awareness of the dreadful anniversary but >> I remember thinking that it sure was some unusual sounding thunder: >> the rumbles were long and building rather than quick and decaying. >> >> 73, >> Drew >> AF2Z >> >> >> >> >> On Wed, 14 Sep 2011 15:55:31 -0400, Alan wrote: >> >>> Hello, >>> Unusual electrical storms here on top of hill on Sunday evening (9/11). >>> On Saturday, the roofing contractor finished putting half of metal roof >>> on house. Received lightning strike to roof (I think), but saw flash >>> onto front walkway. Heard explosion right at my wall. Couldn't find >>> point of hit though. Roof was finished Monday. >>> >>> Is that new metal roof a target for the next storm? Never had a >>> lightning strike near here before this. >>> >>> For the curious: Damage was everything connected to my LAN ... Apple >>> MBPro, Mac Mini, MacPro I/O, router, hub, soundcard connected to K3 on >>> old Windows PC. The K3 ant and power were disconnected (but two audio >>> cables from old PC were connected to K3): my K3 is shot and on its way >>> to Elecraft. A Comcast TV box was shot, and the tel and Internet all >>> needed reset from Comcast. Still finding problems ... >>> >>> Limping along with old Win-2000 PC. >>> >>> Cheers, Alan >>> >>> Alan D. Wilcox, W3DVX (K2-5373, K3-40) >>> 570-321-1516 >>> http://WilcoxEngineering.com >>> http://eBookEditor.net >>> Williamsport, PA 17701 > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
