With an RF probe, I did not get any reading from the first test point, PRE (premix) nor the latter test points in the manual. I do get a good reading on pin 4 of P1 on the filter board which should be the premix oscillator signal. I do get the correct voltages on U7 on the RF board when checked per the voltage table instructions.
I do not get a reading on pin 6 of P1 on the filter board which should be the premix signal output. Any suggestions would be much appreciated. I will double check some things. Mike K7MH. -- View this message in context: http://elecraft.365791.n2.nabble.com/Voltages-for-Q5-and-U8-tp6825928p6829593.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
