Hello,
well, I spend all the night trying to fix this problem without luck. What I did was to connect the SO2RXlat when the K3 was ON and connected to the computer with the RS232 cable. After that I have this ERR DSE, when I connect N1MM to control the radio and I am in CW mode (no problem in SSB) Sometimes the K3 was without RX!!... I turned it off, quit N1MM, turn K3 on and all was OK. I disconnected the USB of the Piexx SO2RXlat, no luck I installed twice the firmwares on the K3, no luck. I installed again the N1MM full installer software and latest version, no luck I changed the COM port number, no luck I connected another computer, no luck So, no idea what happened when I installed this Piexx box!!! Any help? thanks, Jorge CX6VM/CW5W De: Jorge Diez - CX6VM [mailto:[email protected]] Enviado el: Domingo, 02 de Octubre de 2011 01:26 a.m. Para: 'Elecraft Reflector' Asunto: ERR DSE Hello I am trying to instal Piexx SO2RXlat for the DXDoubler to be connected to a USB port. Now I see this in my K3 display E 0400C8 ERR DSE >From the manual ERR DSE say reload DSP1 firmware Really I need to do that? How? I don´t know what´s bad when I wanted to install Piexx SO2RXlat Any help? thanks! 73, Jorge CX6VM/CW5W K3 #4077 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
