Well I just finished my kit and I power it up and press the HV button as instructed to, and I get .1V on the LCD. If I do press operate I get a hard fault of 270V error. I checked the interlock switch and it's ok. I also powered up the unit with the rear panel off and measured the actual 270V line (gray wire) and it measures 11 volts. Sigh, without a schematic, I'm not sure where to go at this point. I'll send an email to support but I guess I'll have to wait to the week days. Anyone have any ideas?
Thanks, Tom VA2FSQ -- View this message in context: http://elecraft.365791.n2.nabble.com/My-KPA500-has-no-270v-tp6897042p6897042.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
