It's in the firmware release notes. MCU 4.31 / DSP 2.72, 3-23-2011
< other text removed > Remote-Control/Switch Macro Command Changes: * "AP" COMMAND TURNS APF ON/OFF: You can turn the CW audio peaking filter on/off by sending "AP1;" or "AP0;", respectively. Applies only in CW mode with CONFIG:DUAL PB set to APF. (Not yet available for direct sub receiver control. Swap VFOs or do A>B copy in order to set up sub receiver APF.) You can use this command to create a TAP function to turn APF on/off; use the Help function in K3 Utility for details on macros. Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Georges Ringotte F6DFZ Sent: Wednesday, October 19, 2011 11:05 PM To: [email protected] Subject: [Elecraft] AF peak filter Hi to the group, Is it possible to write a macro command switching on or off the AF peak filter ? I do not see anything in the programmer reference document. Best regards Georges ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
