Hi Alan, Exactly! Please let it happen soon!
To speedup the project, I could provide the built K2 IF Buffer Interface with cables/connectors (including the noise blanker if desired). A picture of my installation will be sent to your direct e-mail address. Ok? 73, Heinz HB9BCB -----Ursprüngliche Nachricht----- Von: Alan Bloom [mailto:[email protected]] Gesendet: Freitag, 21. Oktober 2011 21:04 An: Heinz Bärtschi Cc: [email protected] Betreff: Re: [Elecraft] K2-P3 Interface Project Hi Heinz, K2 support for the P3 has been on my list for a long time. I have a K2 with RS-232 interface option and the Z10000 kit which I still need to install. There are a couple other features ahead of it in the list, but I would really like to get to it. When it happens, it will only require a firmware upgrade to the P3. The K3 has several P3-specific commands that don't exist in the K2. That means in particular that fixed-tune mode is not possible with the K2. Also the K3 uses a special protocol to talk to the P3 which is not implemented in the K2. However, I think I should be able to get reasonably-good integration between the two so that you can read out the proper frequency on the P3 display, click-to-QSY etc. 73, Alan N1AL ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
