Yes, that would work, but then I would also have to take the K3 with me as well. Trying to travel "light".
Several have made the suggestion to place back to back protection diodes on the P3 input, set the P3 to a convenient below 22mhz frequency, tune the rig being tested to that frequency and the P3, being a self contained receiver, will show the waveform. I think this is the direction I will go. -lu-w4lt- ------------------- Message: 21 Date: Mon, 24 Oct 2011 17:52:43 -0700 From: Alan Bloom <[email protected]> Subject: Re: [Elecraft] P3: Can the Panadapter be used with a Ten Tec Orion 1? To: [email protected] Cc: [email protected] Message-ID: <1319503963.1589.3.camel@ulinux-desktop> Content-Type: text/plain; charset="UTF-8" Hi Lu, Why not just tune the K3 to the RF output frequency of the Orion? The K3's IF output signal is picked off before the crystal filters, so the P3 shows the actual unfiltered signal received at the K3 antenna connector. Alan N1AL ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
