Hi folks -
I wonder if somebody can confirm part of the instructions on page 47 of
the KPA100 manual. I have the KPA100 connected to my K2. The KPA100 is
lying with the heat sink down and the fan to the rear next to my K2. In
this position all component labels are upside down.
The errata for page 47 says to "touch the left side of R12 (the lead
closest to RFC5)". If you were looking at the board with the component
levels "right side up" this would be the RIGHT side of R12.
SO - this makes me wonder about R6. When the manual says "rotate counter
clockwise" does this mean counterclockwise when you are looking at the
components from a position where all the component labels are upside
down? It seems that it must based on how the left side of R12 is
described. What is correct?
Thanks for any help!
73/Tim NZ7C
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
