Guys; This problem is typically caused by the K3's TX INH input being enabled. Be sure that the Config:TX INH menu setting is set to OFF. I emphasize, this is a K3 setting, not KPA500.
Jack Brindle, W6FB On Nov 25, 2011, at 4:55 AM, Geoffrey Downs wrote: > A similar phenomenon here but not every time. Typically it happens when the > amp is cold (eg having been off overnight) the rear power switch is off and > I switch it on, followed by the front ON switch, then go to Operate. As with > Roger, cycling the front power switch clears it. No key cable by the way, > just the the AUX cable. > > 73 to all > > Geoff > G3UCK > > -----Original Message----- > From: Roger Dallimore > Sent: Monday, November 21, 2011 7:52 PM > > When going into "operate" there is no power output, no lights (asterisk OK). > Switching the power button off then on again and placing it into > "operate," it works fine..Happens every time. > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
