Don,
Thanks for the reply. They stick a little longer than that, but I
checked the transistors and they appear to be in contact over their
entire area.
Thanks again... cannot wait for the fox hunt tonight.
73,
Jason N8XE
W3FPR - Don Wilhelm wrote:
Jason,
If the transistor tabs are in contact with the heat sink over their entire
surface area, you did it right. It is normal for the pins to dtick about
1/8 inch above the board. You can clip them off or leave them as is - your
choice.
73,
Don W3FPR
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
