Manuel, With ribbon cables, that condition can mean that you have the two ends swapped. It also can mean that you have a cable with the plug in the wrong hole.
73, Don W3FPR On 12/3/2011 2:47 PM, manueldeportugal wrote: > Hello everyone, > I was just about ready to assemble the front panel, when I realized the > connector on the 40 pin cable has one position blocked. If one follows the > assembly manual instructions (the red cable to P1...) you cannot plug in the > cable because the blockage is on the wrong side. > > I would very much appreciate your help. > > 73 and thank you > Manuel > LU5OM > CT4IK > KPA-500 # 562 > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
