Make sure the KPA100 option is installed and enabled. That sounds like it is not (the basic K3 has a 10 watt transmitter). Suggest you look in the Owner's manual and perform the procedures to enable and then test and calibrate the KPA100. Likely that will point to the problem.
Good luck! Ron AC7AC -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Robert Mccormack Sent: Saturday, December 10, 2011 2:09 PM To: [email protected] Subject: Re: [Elecraft] K3/100 - High power problem While checking a K3/100 #4114 on behalf of SK estate, I find that the power cannot be set higher than 12 watts. Operation was normal until I commenced a CAL procedure to correct a 2kHz difference between 'indicated' and transmitted frequency. Checked all the menu functions but can't find any reference to power limitation - searched the archives but no luck. Any help is appreciated. 73, Ken ZL1AIH. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
