Hi, I am about to enable remote on/off on my K3 and I just noticed in the manual for the KPA500 that the power ON line must be pulsed to ground and not left low. This is different than what the manual says for the K3 where you are supposed to pull the line to ground until you wish to power off. Why the difference? Any ways irrespective of the reasons, the what is the situation with the Elecraft AUX cable to connect the K3 to the KPA500? I guess that the power on/off lines are not connected right? What this would mean is that one would need two of the Y cables, one at the K3 and another at the amp, right? Assuming that this can be worked out,, how would one turn the amp out of standby? Can this be done by the K3? Thanks for any insight into this.
Tom VA2FSQ -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-and-KPA500-aux-power-on-difference-tp7095755p7095755.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
