Slope >0 flattens the agc response. Have a look at some curves on The AGC Story on ke7x.com
-----Original Message----- From: [email protected] on behalf of Arie Kleingeld PA3A Sent: Thu 12/15/2011 3:08 AM To: [email protected] Subject: Re: [Elecraft] K3 AGC Mod Test This Weekend Dennis, Thanks for this try-out! I'm looking forward to hear the results. Some suggestions: - switch the PLS off. My experience in CW contests is that the PLS function will treat fast strong CW signals as pulses and will bypass the slow AGC for the first few dots of a signal. - maybe set the SLP to 8 or higher. This will make the AGC more active in your test - set AGC to F 73, Arie PA3A Op 14-12-2011 22:53, Dennis schreef: > AGC parameters: > DCY Soft > HLD .30 > PLS Nor > SLP 000 > THR 008 > F 120 > S 020 > AGC as selected using front panel push button will be "slow". > All RxEq will be flat, ie. 0 > Preamp Off > Att- haven't decided on this yet, but both radios will be the same. > Crystal Filter- 400Hz > Bandwidth setting- 400Hz > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
