Stephen, Is there a place for C12 and C13 on the top of the board? If not, place them on the bottom as shown in the instructions for the Rev C board.
73, Don W3FPR On 12/17/2011 3:02 PM, Stephen Prior wrote: > This is reposted, since I never saw it appear on the list, apologies if it's > a dupe. > > AnywayŠŠŠŠ.. > > > I'm just about to build the K1 noise blanker to take my mind off the KX3! > > In the errata sheet, I am confused by the change to the bottom of page 5: > 'If your board is revision C, solder .........' > > I have looked at the print on the pcb and it says Rev. Cr > > Is that revsion C or not I wonder? I know it's not A or C, but to my mind > Cr does not equal C! > > Thanks > > Stephen G4SJP > > PS. To UK readers of this, I ordered the kit from QRP project in Germany > and paid less than I would have done direct from Elecraft once the shipping > was taken into consideration. > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
