Anyone have a source for short jumper plugs for the mic config header in
the K2? I have some from a microprocessor project, however the part
that goes on the pin is too long to fit between the front panel and
control board. I'm hoping to avoid soldering jumpers to the header pins
(which I already know isn't the easiest or prettiest of tasks).
73,
Fred K6DGW
Auburn CA CM98lw
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
