I had the exact symptom when I first built my P3 .... I had installed the RF board in the P3 upside down (yes, it is possible to do so!), so I was actually connecting the IF in to the output jack of the P3 instead of the input jack ... silly error ... perhaps you can benefit from you carelessness and that is your problem?
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Bill Conkling Sent: Sunday, January 01, 2012 1:10 PM To: [email protected] Cc: [email protected] Subject: [Elecraft] K3/P3 DOA Friends, My good friend and elmer Mark (n1lo) recently purchased a pre-loved K3 and treated himself to a P3-K for Christmas. I visited him yesterday, and watched as he assembled his new 'toy'. All went pretty well, until we hooked it up. It all seems to work, except, there is no signal showing on the P3 screen. All the markings are there, display seems to be working, but no signal. Adjusting the "REF LVL" brings up 'noise' but removing the BNC cable does not change the display. Tried connecting to the IF OUT connector and turning the switch 'ON' made no difference. Tried another BNC cable, same result. Opened the P3 and checked the TMP cable but it was firmly connected at both ends. No change. He has emailed support for assistance but it is New Years and may not hear anything immediately as expected with the holiday and all. So, it the mean time, anyone here have an idea that we haven't thought of? He did the mod to the radio to increase the output, but that looks good. ...bill nr4c (for Mark n1lo) ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ------------------------------------------------------------ This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email. ================================= ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
