Don Wilhelm-4 wrote > > Steve, > > This Elecraft email reflector stopped being the K2 reflector as soon as > the K1 was available, and now there are questions about the K3, K2, K1, > KX1, now the KX3, KPA500, KRC2, mini-modules, and any other product that > Elecraft has produced or has announced for the future. > > Clifton Labs Z10000-K2 buffer can be installed in the K2 to provide > IFoutput for your spectrum analyzer. Look at > http://www.cliftonlaboratories.com/z10000_buffer_amp.htm. > > 73, > Don W3FPR >
In regards to the reflector/forum - I posted on the website under the K2 forum. There are also categories for the K1, KX1, K3, etc. I am not using the e-mail system to get the post in to the reflector. I forgot that the e-mail list does not "categorize" posts in the same regard that the website does for the reflector. Just playing around here - I dug out my manual and found the RX Mixer. I tapped the Post-Mixer Amp side of C159 and the ground side of R80 with a length of RG-174. Then I ran that back to the receive antenna connector on the 160 module (desoldered the wires to the 160 module). I figured this would give me a 4.915mHz reference from which to tap but it doesn't work too well. There's more to learn here for sure. I figured there would be a place in the circuit I could tap to bring out the IF to the analyzer. Would I not be correct in assuming that the spectrum analyzer can read the same signal(s) fed to the rest of the K2's receiver? -- View this message in context: http://elecraft.365791.n2.nabble.com/IF-tap-tp7144523p7145046.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
