Good Morning. I downloaded and installed Fldigi last evening and have the
k3.xml file installed for the rig interface. The only problem is that when I
switch to cw on my K3 and then change Fldigi to cw the program will not decode
the code received. But if I switch the K3 to data then Fldigi to cw then the
program will decode the cw. I know this can't be the way that it should be, but
don't know enough about Fldigi to make the necessary changes in setup. Plus if
I try to send anything with the K3 in data it will transmit in the mode that I
have picked which is PSK31. Any help or suggestions would be much appreciated.
Thanks!! Mark KB3Z
------------------------------
Sent using Verizon.net Mobile
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
