Jeff, When I try to use CW, all I get are transmitted dits or dahs. The breaks register as zero output, so the needles on the amp bounce around and are hard to read. Any suggestions on using CW to generate that continuous carrier out to the amp so that the needles don't bounce around and I can adjust it properly?
Thanks and 73, --Ian Ian Kahn, KM4IK Roswell, GA [email protected] K3 #281, P3 #688 On 1/19/2012 10:59 PM, Jeff Cochrane - VK4BOF wrote: > Use CW mode > > 73 de > Jeff Cochrane - VK4BOF > East Innisfail > QLD, Australia > K3 #4257, P3 #1629, KPA-500 #161 > > ----- Original Message ----- From: "Ian Kahn - Ham" <[email protected]> > To: <[email protected]> > Sent: Friday, January 20, 2012 1:51 PM > Subject: [Elecraft] Tuning AL-811H > > >> I have a question about tuning an AL-811H amplifier with my K3. When >> I used my FT-857D in the shack, I would tune to the antenna in FM >> mode. However, I don't have the FM filter on my K3. I tried tuning >> the amp using AM, but I don't have that filter either. So, what is >> the best mode to use that allows me to briefly transmit an >> uninterrupted carrier so I can get this amp set up and the settings >> written down? BTW, after going through this, the saving for the >> KPA500/KAT500 will soon begin. >> >> Thanks everyone for the assist. >> >> 73, >> >> --Ian >> Ian Kahn, KM4IK >> Roswell, GA >> [email protected] >> K3 #281, P3 #688 >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
