Joel, The K3 has an indicator for the proper audio input level - it is the ALC meter. For data modes, adjust the audio output to have 4 bars lighted with the 5th bar flickering. The old advice normally seen to not have any ALC meter activity. The K3 ALC meter is different - the onset of ALC is the 5th bar, below that level it behaves more like a VU meter to allow you to easily set the audio level.
73, Don W3FPR On 1/30/2012 6:36 AM, Joel Black wrote: > I have finally gotten the KAM+ working with the K3. > > Lots of helpful suggestions here as usual. > > To start off my problem, I wound up having the TxA and RxA connections > reversed. Once I got that corrected, I could receive just fine, but I > could never transmit (no audio using MON and no transmit power). Well, > after reading the manual yet again, I found a jumper for increasing the > TxA from the KAM and a pot that adjusts that output audio. I could then > hear the signal, but I still had no output power. Adjusting the MIC > gain solved that. I think the audio from the KAM may be a little hot so > I am still playing around with that. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
