My K2 serial number#7144 is almost completed. All tests have been good except
the last resistance check on page 76.
Collector to ground should read 0 ohm,s .Even without the heat sink on I
get 3.6K.Looking through the E mail's that are posted I have removed
transformer T3,recheched the collectors of Q7 and Q8,I get a reading of 0
ohm's all good.I removed Q7 and Q8 so I can get a beter look at what is
going on .the collector pads to ground without T3 are good,but when I short
out pads A and B for T3 where the windings will go I get reading of 3.6K.
Eye balling the board for shorts,I can't find a thing wrong and T4 windings
look good to me.
Any ideas before I pack this thing up and send it off for repair.
Leo KG6WNI
--
View this message in context:
http://elecraft.365791.n2.nabble.com/K2-power-amps-Q7-Q8-tp7237418p7237418.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
