But that would be a rate and it might be pretty big :-)
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Mike Sent: Tuesday, January 31, 2012 4:44 PM To: [email protected] Subject: Re: [Elecraft] macro to control KPA500 If you measure the hand motion required in furlongs/fortnight, it's a very small number... 73, Mike NF4L On 1/31/2012 3:34 PM, Tony Estep wrote: > Thanks to all who kindly replied to my query. I am completely > convinced that it can't be done. > > As I said to Dick Dievendorff, I was hoping to save a few hundred > gram-centimeters of work per day, maybe even more on a busy day. Now > that hope is gone, and I have expended even more by writing the > original query and this email; that's energy I'll never get back. Such > is life. > > 73, > Tony KT0NY > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net Please help support this email > list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
