Mats, Check your config menu for TX DLY. You may need to reduce it some. This is from the manual:
(Advanced) For use with external amplifiers that have slow relays; sets the time from KEY OUT jack (active low) to first RF in 1-ms steps. To minimize loss of QSK speed, use the shortest delay that works with your amp. Most will work with the default (minimum) setting of 8 ms. CAUTION: If you use any setting above 008, and you’re using an external keyer in CW mode, you should listen to your keying on another receiver. At some code speeds and keyer weight settings, your CW keying may exhibit excessive jitter (per-element variation) that can be heard on the air. Note: If CW QRQ is set to ON, the minimum delay from KEY OUT to first RF will be somewhat shorter (approx. 4 to 5 ms rather than 8 ms). 73 Greg AB7R On 2/6/12, MATS OLOFSSON <[email protected]> wrote: > Hallo! > > > > I have a problem with my K3 together with N1MM and K1EL. > > It seems that the signs, dots and dahs, get to short working with this > setup. When I have been working with my Yaesu FT 1000 Field there is no > problem with this. In speeds about 33-41 word per minute it sounds very odd! > > > > > Has anyone had this problem? Any hint to solve this? > > > > It does not help to change the weight in the menu, that only helps the > internal keyer. > > > > 73 > > > > /Mats SM7GIB > > > > PS. K3 is the best rig ever! ;-)) > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
