Yes Chuck. Mine does the same thing. T thought loosing the side a bit might make it "pop" back flush and then retighten the screws but that didn't help. Your right, it does detract a bit cosmetically from the amp (which is a great product) I now have my month old KPA500 interfaced with my day old K3. Nice combination.
John KE4D K3 SN 6226 KPA500 SN 636 Brackettville, TX Message: 17 Date: Fri, 10 Feb 2012 18:54:43 -0800 (PST) From: Chuck - AE4CW <[email protected]> Subject: [Elecraft] KPA500 Z Bracket & Top Cover To: [email protected] Message-ID: <[email protected]> Content-Type: text/plain; charset=us-ascii Just finished a KPA500 build and all went smoothly. The only issue I see is that the Z-Bracket appears to be about 1mm taller at the front than at the rear. The result is that the top cover protrudes above the front panel in the center by a small amount, perhaps 1mm. At the rear the top cover is flush with the rear panel in the center...no protrusion at all. This is a cosmetic issue but does detract a bit for the "fit and finish" of the rest of the KPA500 and the K3. Has anyone else seen this issue? Thought I would ask before calling home. --- Chuck, AE4CW Libby and John www.TheRollingHome.com Ft Clark Springs, Brackettville, TX No trees were harmed in the sending of this e-mail; however, many electrons were inconvenienced ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
