If you make TWO jumpers, one on the PA end and one on the main board end, then the current sensor on the riser board will still be in play. This is a fine permanent fix, you just will have to unsolder if you take the PA and riser out. Keith I have pictures, but I think they will be stripped.
On 2/14/2012 2:14 PM, Don Wilhelm wrote: > Buck, > > The "bypass surgery" is a method of soldering wires around the KPA3 > connectors that carry high current 12 volts. I have seen the pictures > and words in the past, but I cannot locate them right now. > You would do better to change the connectors. I know the "bypass > surgery" has been used as an emergency measure to get a K3 working while > on a DXpedition. > > 73, > Don W3FPR > > On 2/14/2012 4:25 PM, Buck - k4ia wrote: >> Don't tease us like that. ;-) What is the "bypass surgery" method? I >> don't remember seeing it. >> >> >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
