Mike,

Are you transmitting into a dummy load, or into an antenna.  If you are 
transmitting into an antenna, I have to ask - what are the 
characteristics of your antenna on each band that you make reference to 
- I need to know the resistance and the reactance, not just the SWR.

73,
Don W3FPR

On 3/1/2012 8:04 PM, Mike Anderson wrote:
> I've noticed some weirdness with transmitting on higher bands on my
> elecraft.
>
> Down on 40, and 80, its great. When I transmit the RF meetings goes
> almost all the way the up. My w2 responds and shows a good output as well.
>
> However on 20, 15, 17, the RF meter won't even get over 50, it shows
> maybe 1 or 2 bars at peak. Now my SWR on 20 is 1.6 so I assume that it
> will put out less power but not that big of a loss. I also get a "hi
> Curr" on 20 when i hold down the xmit/tune button and transmit that way,
> even though I am putting 14.5 v into the k3. It shows 12.6v during
> transmit.  I do show the meter as showing it drawing almost 23 amp
> during transmit on 20, the rest of the bands are about 14amp. Again
> these readings are measured when i hold down the XMIT button.
>
> On 10m i get a 1:1 swr match, and it does the same thing, barely no RF
> output. So I am not convinced its a SWR match thing.
>
> Have I missed a setting somewhere? Somewhere that I have to turn this
> up. I have the PWR turned up to 110.
>
> Anyone have any ideas?
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft@mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Reply via email to