Yes, both of you were right. I use only ANT1 & 2 and I checked them before. Have not checked the AUX input and the sub was set to AUX. Slow mind on Sunday, thank you for the help. 73'
István Szabó On 3/4/2012 4:00 PM, Guy Olinger K2AV wrote: > Main ant vs. aux/other ant ant is saved separately by band and which > RX, which might cause one the sub RX to seem off as that state is only > displayed after BSET (hold on A/B button). Also true of ATT/PRE. This > is also true of the NB and NR state and selection. If those are set > to a "hard" quieting, the RX might seem off. > > 73, Guy > > 2012/3/4 István Szabó <[email protected] <mailto:[email protected]>> > > Just observed that the subreceiver of my K3 does not work on 14 MHz > only. When I tune the sub it looks like that the VFO changes its > frekvency as I hear "spurr" while tuning. No signal heard coming from > antenna input. This phenomena is on 20m only the rest of the bands are > fine. No difference between modes. Where shall I start the diagnosis? > > 73' > István Szabó > HA4ZD > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > <mailto:[email protected]> > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
