Thanks, I will try and let you know my result !!!
73
Le 05-07-24 à 07:32, W3FPR - Don Wilhelm a écrit :
Jean-Francois,
You certainly could do that - it should not alter any other
function that I
am aware of. The current display can be trimmed by changing
Control Board
R7.
R10 and R7 are 1% resistors, and that provides repeaability from
one K2 to
another - one could hand-pick from 5% resistors just as well.
I personally would be concerned about leaving a trimmeer in place
because of
the possibility of the setting being changed, but certainly using a
trimmer
to determine the exact value required would be an easy method.
73,
Don W3FPR
-----Original Message-----
Hi Don,
You said : "By lowering the value of R10 ..." Could I just put a
trimmer near that value instead of R10 and tune the trimmer so that
the voltage displayed match more closer the real external voltage ???
And could I do limilar thing with the current display ???
I don't want to be more catholic than the Pope, but is it possible to
do those mods ???
Best 73 from a junior ;-)
Le 05-07-23 à 18:56, W3FPR - Don Wilhelm a écrit :
Steve,
Although some have been confused by the readings at first, I don't
see any
advantage in modifying the internal voltmeter to read the external
supply
voltage - what it reads is the actual voltage the K2 is operating
at - but
if changing it is your choice, by all means do it - it should be a
simple
task of padding R10 (or lowering its value a bit).
======
Jean-François Ménard / VA2VYZ
======
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.9.4/57 - Release Date:
7/22/2005
======
Jean-François Ménard / VA2VYZ
======
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
