That is the correct procedure. If it happens again, your tx gain calibration may be getting messed up. Do not "TUNE" at exactly 5 or 50 watts into other than a flat SWR as that will reset the calibration. See TXGN in the manual under config menu items. Keith
On 3/5/2012 5:35 AM, Adriano Perazio wrote: > It was discussed few days ago about a problem of low power output on the k3 > sometimes – bu i don´t remember the solution. > Well i had noticed that issue during day by day operation and solved after a > turn on-off-on. > But this weekend during the ARRL, it happened many times. The radio went to > 5w only or so. > Only once i saw an error on the lcd: ERR TXG. > I found a “solution”: on the k3 utility: re-calibrate the radio w/ a dummy > load. > Anyone could help on that? > > Tnx > > PY2ADR / PR2X > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
