Hi Elecrafters, just decided to upgrade my KRC2 firmware from V1.0 to V1.3.
I installed the KRC2 Download Utility V1.1, connected my KRC2 to the PC, set the switch to download. Then I made the following: - Press button "Get F/W Rev." - KRC2 responds "V1.0" - selected the HEX file - press "Download KRC2", KRC2 LED starts flashing - program says "KRC2 failed to reply" (well, it did before ?) After trying this several times I decided to switch off Options/Ack Req'd and started again. Now no error message comes up, but ... NOW MY KRC2 IS COMPLETELY DEAD. Upon power-on the LED comes up in DIM mode, but nothing more happens. It doesn't set any outputs nor does it reply on button presses. Well, I think, my KRC2 lost its brain. I have a programmer available. So no difficult task to flash the MCU directly, but the HEX-file supplied seems to be a somehow modified INTEL HEX file. What do I have to do in order to put life back into the MCU ? Your help is very welcome. VY 73 de Marcus, DL1EKC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
