Tap MENU, rotate VFO B to "LCD BRT", if it says "DAY" then rotate VFO B to desired backlight. Keith
On 4/6/2012 11:35 AM, Bill wrote: > This is rather dumb question; Since I built my K3 over two years ago, my > eyesight, which was failing at that time, has now reached the legally blind > state. I have developed a simple problem - panel lights go out after power > is applied for about two seconds, but rig continues to work FB. If I could > see inside the rig, I am sure I could isolate and repair what sounds like as > relay closure causing the lights to go out, in about ten minutes flat---but > with my vision this is now impossible. > > Is there any one out there who does "minor" repairs such as the above??? I > keep reading about the turn-around time at Aptos,and do not wish to compound > the problem with my "silly " repair job. Also a round trip to CA seems as > little over the top. My QTH is Palm Beach Florida. > > Any leads would be appreciated. > > Bill Hartman > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
