You may have to manually set the K3 to 38400 baud ("RS-232" in the
CONFIG menu). I found out that the P3's auto-baud routine was broken in
version 1.06 (and subsequent) firmware. It will be fixed in the next
update.
Alan N1AL
On Mon, 2012-04-16 at 11:17 -0700, Bill Wiehe wrote:
> Checked the cable and nothing appears to be wrong.
> Bill - W0BBI
>
>
> ________________________________
> From: Bill Wiehe <[email protected]>
> To: "[email protected]" <[email protected]>
> Sent: Monday, April 16, 2012 12:16 PM
> Subject: P3 Frequency
>
>
> Just completed my P3 and hooked it up the K3. everything works fine except
> that is does not display the center frequency and the qsy function for MKR
> and B does not work.
> Any direction would be appreciated.
> Thanks
> Bill - W0BBI
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
