Byron, No, you cannot get a probe to TP3 with the KDSP2 in place. However, unless you have identified a problem that has occurred since the last time you checked the PLL Reference range, it is not likely to change. I would say skip it - but if you find other PLL "strangeness", then remove the KDSP2 to check it.
73, Don W3FPR On 4/21/2012 4:50 PM, Byron Servies wrote: > Hi there! > > Last week I finished my now fully loaded K2 #7077 and thought I would > go through and re-do all of the various calibration steps. It became > immediately clear that TP3 is now covered by the KDSP. > > Is there a recommended way to perform these calibrations with the KDSP > installed? > > 73, Byron N6NUL > K1 #2799 > K2 #7077 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
