Hi all, So far I thought I was doing great. Just to save some time I thought I would ask the collective before I go digging for misplaced components and solder bridges.
I am building a K2 for a friend. I am at the first point of power up testing. Control board, front panel and a few components on the RF board. I got the INFO 201 for about 10 seconds, then the display flashed Elecraft and then 7100.00 as it should. Now the problem. No front panel function. At all. No buttons work and the frequency will not change via the encoder. Also one in 5 power ups the LED display will light all segments and the backlight on the display will come on, but that is all. I have done a good visual and see no components unsoldered or shorts. I am extremely careful when building and usually don't have any problems when building. Maybe it is just my turn. Any and all suggestions would be appreciated. I am thinking firmware perhaps. Jess AE0CW <>< _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
