At present it is not possible to lock the KX3 to an external reference. Wayne N6KR
On May 1, 2012, at 8:20 AM, Edward R. Cole wrote: > I have the new VHF ApolLO synthesizer board from N5AC (marketed by > DEMI) and wondering if I could somehow use it to drive the KX3? What > is the main reference oscillator frequency? What level of signal is > produced? > > The ApolLO can be programmed over a range of 78 to 409 MHz so if the > KX3 runs at 49 MHz like the K3 one could run 98 MHz and add a > divider. This might require special programming of the synth by N5AC > but just wondering. > > This would be an external module (size: 3x4x1/2 inch). One could > take this one more step and add a GPS receiver for portable > operation. The GPS would provide the accurate reference > signal. These are now available with tiny patch antennas integrated. > > > 73, Ed - KL7UW, WD2XSH/45 > ====================================== > BP40IQ 500 KHz - 10-GHz www.kl7uw.com > EME: 50-1.1kw?, 144-1.4kw, 432-QRT, 1296-?, 3400-? > DUBUS Magazine USA Rep [email protected] > "Kits made by KL7UW" http://www.kl7uw.com/kits.htm > ====================================== > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
