IIRC, when I installed mine I had to touch up the offsets a bit to get good audio. Now it sounds good transmit and receive. Got the counter out and touched up the HF freq, then did the 2 meter. Keyed up into dummy load and dialed in the frequency that was on the display by changing the offset.
Jim K0XU Sent from my Xoom tablet On May 4, 2012 9:51 AM, "Julie Royster" <[email protected]> wrote: > NG5E wonders if Larry and I are new to using a VFO on the 2-meter band, but > that is not the case, and tuning does not seem to be the issue. > > The Elecraft support staff (both Dale and Howard) have been quite attentive > and helpful. They have offered to check out the K3 in its entirety. We > are > not criticizing Elecraft support. > > We have heard from a few people with a similar problem. It may well be a > function of the local repeaters, not the transverter or the K3. We are > attempting to find out the transmit bandwidth of the repeaters in question > (which could be wider than the 13kHz filter), and we are asking another > local K3 owner to determine if he also gets distortion or clipping on the > same repeater. > > 73, > Julie Royster KT4JR > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
