Hi,
After Gary (KI4GGX) recommandation and explanation, I finally redo
from scratch the KNB2 jumper... Yes in deed, it was a little bit
harder to do. I should be able to keep the clearance at about 1/2"...
I hope. ;-)
I did a photo of the jumper before applying tape and sticker. And I
use one 560 Ohm resistance instead of the 470 Ohm.
http://homepage.mac.com/jfmenard/PhotoAlbum29.html
Thanks again Gary !
73
J-F / VA2VYZ
Elecraft K2 #4130 / KX1 #999
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
